Top 10 L298N Motor Driver – Electrical Motor Controls

As an Amazon Associate I earn from qualifying purchases.

1. ALAMSCN

#ad

ALAMSCN 6PCS L298N Motor Driver Controller Board Module DC Motors Dual H-Bridge with Jumper Wires Kit for Arduino Smart Car Robot Power UNO MEGA R3

#ad
ALAMSCN #ad - Jumper wire kit: 20cm jumpers, male to Male, Female to Female, Male to Female each 20Pin. It comes with 6pcs motor drive modules and 60pcs jumper wires for different interfaces, which can meet your project needs. Motor drive controller: l298n used as the main driver chip. Not recommended for stepper motors. It has the strong driving ability, low calorific value and strong anti-interference ability. This is a good motor drive for an arduino and raspberry pi based RC car project. Note: suitable for dc motors in smaller projects, but not for prototyping.
BrandALAMSCN #ad
ManufacturerALAMSCN #ad
Height0.39 Inches
Length0.39 Inches
Weight0.04 Pounds
Width0.39 Inches

2. AiTrip

#ad

4Pack L298N Motor Drive Controller Board DC Dual H-Bridge Robot Stepper Motor Control and Drives Module for Arduino Smart Car Power UNO MEGA R3 Mega2560

#ad
AiTrip #ad - Using l298n made by st company as the control chip, the module has such characteristics as strong driving ability, low calorific value and strong anti-interference ability.

Using large capacity filter capacitor, this module can follow current to protect diodes, and improve the reliability. Dual-channel H-bridge driver working mode creates higher working efficiency. To avoid damage the voltage stabilizing chip, please use an external 5V logic supply when using more than 12V driving voltage. This module can use built-in 78m05 for electric work via a driving power supply part. But to avoid the damage of the voltage stabilizing chip, please use an external 5V logic supply when using more than 12V driving voltage.
BrandAiTrip #ad
ManufacturerAiTrip #ad

3. Aideepen

#ad

Aideepen 5pcs 1.5A 2 Way DC Motor Driver Module Speed Dual H-Bridge Replace Stepper L298N

#ad
Aideepen #ad - Minimal heat, no heat sink, low power consumption, small size, is ideal for battery powered. Dual 1. 5a * 2, do not be afraid motor stall burned, built-in thermal protection circuit, the peak current to be 2.5a, automatic recovery after the temperature dropped. Use of imported original chip, built-in low on-resistance MOS switch. Dual h-bridge motor driver, can drive two DC motors or a 4-wire two-phase stepper motor. Small size, 0 standby current, light weight, is the ideal choice for your car model.
BrandAideepen #ad
ManufacturerAideepen #ad
Part Number0113395

4. Relkin

#ad

L298N Motor Driver Module Controller Board Dual H-Bridge With Robot Stepper DC TT Motor 1:48 And Smart Car Tire For Arduino Smart Car Power UNO MEGA R3 Mega2560

#ad
Relkin #ad - Use large-capacity filter capacitors and diode with freewheeling protection function, large capacity filter capacitance, increasing reliability, afterflow protection diode, more stable and reliable.

Yellow biaxial tt motor with 1:48 reduction ratio, electric motor operating voltage: dc 3v-6v recommended 3v, great for robot car diy or other electronic production, with emc, it has an anti-interference ability. Toy wheels material: plastic, tire diameter: 65mm, tire width: 25mm. L298n as main driver chip makes strong driving ability and strong anti-interference,, drive stepper dc motors to work. To avoid damage the voltage stabilizing chip, dual-channel h-bridge driver working mode creates higher working efficiency, please use an external 5v logic supply when using more than 12v. Package: 1pcs l298n module, 4pcs car tire, 4pcs DC TT motor.
BrandRelkin #ad
ManufacturerRelkin #ad
Part Number4T298

5. WGCD

#ad

WMYCONGCONG 5 PCS L298N Motor Drive Controller Board Module Dual H Bridge DC Stepper Module for Arduino

#ad
WGCD #ad - Package: 5 pcs l298N motor controller board module. Size: 43 * 43 * 27 mm/1. 69 * 1. 49 * 1. 06in. L298n main driving chip, low calorific value, high drive ability, strong anti-interference capability. Dual h bridge dc stepper module, more stable and higher work efficiency. With built-in 78m05 to supply power, to avoid the damage of voltage regulator chip, when the driving voltage is greater than 12V, please use the external 5V logic power supply.
BrandWGCD #ad
ManufacturerWGCD 1 #ad
Part NumberL298N-MOTOR-5P

6. Dmyond

#ad

Dmyond DC Motor Driver MX1508 Mini Dual Channel 10pcs 1.5A L298N PWM Speed Controller Dual H-Bridge Replace Stepper

#ad
Dmyond #ad - Use of imported original chip, minimal heat, small size, low power consumption, no heat sink, built-in low on-resistance MOS switch, is ideal for battery powered. Each can provide continuous current of 1. 5a, peak current up to 2. 5a, thermal protection and can be automatically restored. Supply voltage 2v ~ 10v, can drive two dc motors or a 4-wire 2-phase stepper motors, can achieve forward rotation or reverse rotation, it is possible to adjust the rotation speed. Motor drive module is ideal for use in battery-powered smart car, toy cars, robots.
BrandDmyond #ad
ManufacturerDmyond #ad

7. KOOBOOK

#ad

KOOBOOK 5Pcs 2.5A Dual Channel DC Motor Driver Mini Module Beyond L298N PWM Speed Control

#ad
KOOBOOK #ad - With built-in thermal protection circuit, the temperature automatically after the recovery. L298n internal transistor switch, need to heat, the market is very easy to burn the L298N, bulky, low efficiency, high fever, are not using the original chip, this product can be replaced.

Currently on the market of intelligent car voltage and current are in this range. Small size, light weight, 0 standby current. Two-way h-bridge motor drive, can drive two DC motors or one 4-wire two-phase stepper motor at the same time. Dual 2. 5a x 2, do not worry about the motor stall burned, is more power than 1. 5a motor-driven version. Original professional motor drive chip, heat is minimal, builting-in low-conduction internal resistance MOS switch, no heat sink, energy saving, is your ideal choice when you use battery as power supply.
BrandKOOBOOK #ad
ManufacturerKOOBOOK #ad
Part NumberKB018

8. HONBAY

#ad

Honbay L298N Motor Drive Controller Board DC Dual H-Bridge Robot Stepper Motor Control & Drives Module for Arduino Smart Car Power UNO MEGA R3 Mega2560 Duemilanove Nano Robo

#ad
HONBAY #ad - L298n as main driver chip makes strong driving ability/small heating/strong. This module can use built-in 78m05 for electric work via a driving power supply part.

But to avoid the damage of the voltage stabilizing chip, please use an external 5V logic supply when using more than 12V driving voltage. L298n has such characteristics as strong driving ability, low calorific value and strong anti-interference ability. Dual-channel H-bridge driver working mode creates higher working efficiency. Using large capacity filter capacitor, this module can follow current to protect diodes, and improve the reliability.
BrandHONBAY #ad
ManufacturerHonbay #ad
Part NumberL298N-1P

9. Solu

#ad

Solu Dual H Bridge DC Stepper Motor Drive Controller Board Module L298N for Arduino//L298N Motor Drive Controller Board DC Dual H-Bridge Robot Stepper Motor Control & Drives Module for Arduino Smart Car Power UNO MEGA R3 Mega2560

#ad
Solu #ad - Can drive one 2-phase stepper motor, low heat, one 4-phase stepper motor or two DC motors. L298n as main chip, outstanding anti-interference performance. High working power to 46v, large current can reach 3A MAX and continue current is 2A, power to 25w.

What we pursue is your satisfication of our service, not just for our goods. For any reason you are unsatisfied with our product at any time, Professional factory of circuit boards, simply contact support for exchange or refund. Built-in 78m05, when drive power over12V, however, get power from drive power, please use the external 5v power as power supply. About us solu, welcome to our store for more choices with best price.

We will reply you about any question you ask within 24 hours. Usually, you will get it actually in 9~19 days, if you are in the usa and the item is not fulfilled by Amazon. Hope you will receive your item soon and enjoy using it. The item will be sent to you by USPS with shipping information from China. The estimated delivery time offered by Amazon is not the real time. Your patience is highly appreciated.
BrandSolu #ad
Manufacturersolu #ad
Weight0.02 Pounds
Part NumberCECOMINOD005131
ModelCECOMINOD005131

10. Cytron

#ad

Cytron Maker Drive 1A Dual Channel H-Bridge Motor Driver PWM Speed Controller for Beginner Better Than L298N

#ad
Cytron #ad - Dual channel and Bi-directional control motor driver for beginner. Support motor voltage from 2. 5v to 9. 5vdc. Better performance than L298N. 5v output 200mA to power the controller. Maximum current up to 1. 0a continuous and 1. 5a peak
BrandCytron #ad
ManufacturerCytron #ad
Part Number38514089